|

email: info@roverracks.com
| Tel: ( 941)
235-RACK (7225)
|
|
Cell: ( 941) 421-9300 |
Open 9-5 M-F
1481 Market Circle
Port Charlotte, FL
|
|
3 New Features
are integral to
5th
Generation
ROVER
RACKS
|
-
All welds are checked before rack is powder coated, for look and
strength.
- All racks are made from heat treated & pre-galvanized steel,
so it won't bend under stress. Same weight, stronger steel.
- Harder, more durable hammered powder coating finish is now
standard.
- All Stainless Steel Hardware Included with every roof rack. |
| |
Land Rover Discovery
ROCK SLIDERS
Factory Direct Land Rover
Accessories:
GOT SLIDERS? Ours rock sliders
are not only the prettiest, but the toughest out there. Period.
| Stock Land Rover Discovery I
and Range Rover Sliders - $599
|
|
|
Stock Land Rover Discovery II Sliders - $599 |
|
Made with 1/8 Steel, will take any abuse sent their way, including
big-ass rocks that might damage your beloved oil donor.

|
|
These sliders are nice enough to drive to the office, yet sturdy
enough to take you to Moab, tomorrow. They're very easy to
install, with install time under an hour. All hardware is included, as is easy to follow instructions.
Tools required to install: Flat Screwdriver (to pull sills off),
Electric Drill, 1/2 Drill bit, Permanent Marker, Jack Stands, Floor Jack, and a
friend if one's handy.
|
|
For additional questions
email
|
| Easy to install- You can do it by yourself, with a floor jack.
If you don't have a jack, you'll have to get one....or bribe a friend for
their help.
Help from a spouse or significant other is not recommended.

|
--------------------------------------------------------------------
INSTALLATION INSTRUCTIONS for NWP Sliders:
Tools needed: Flat Screwdriver (to pull sills off),
Electric Drill, 1/2 Drill bit, Permanent Marker, Jack Stands, Floor Jack, and a
friend if one's handy.
1) Pull all existing obstacles off of slider sill
2) Make sure the surface is clean (you'll be making some pen marks)
3) Identify Passenger side Slider
4) Using a floor jack, or jack stands, lift the slider into desired position
NOTE: MAKE SURE TO LEAVE APPROXIMATELY 1/2 inch between slider and doors
so
that your doors still open.
5) Check the slider to make sure it's centered between the front and rear
wheels.
6) Open and close doors to make sure there is enough room for the doors to close
and allow
for mud/rocks
7) Mark with permanent marker where your new holes need to be drilled
8) Lower sliders onto the ground
9) Drill holes through sill
10) Reposition the slider
11) Bolt sliders onto vehicle
12) Repeat steps 4-11 for Drivers side.
RETURN
POLICY: all
returns are subject to a minimum 25% restocking fee and all shipping costs are to
be paid for by customer. all sales are final unless package is damaged in
transit by authorized northwest parts, inc. deliverer. all items are
considered off-road accessories and must be treated as such. Custom Orders may
not be returned.
Order
Cancellation: orders
cancelled after production has started on the order is subject to a nonrefundable
25% cancellation fee. Custom Orders may not be cancelled.
|