email: info@roverracks.com
Tel: ( 941) 235-RACK (7225)
Cell: ( 941) 421-9300

Open 9-5 M-F
1481 Market Circle
Port Charlotte, FL

 

  DEALER INQUIRY
FAQ
HOME
LADDERS

ROCK SLIDERS
ROOF  RACKS
SHIPPING

Be the 1st to know about Specials & New Products

Join Our
Mailing List


Join List
Remove


3 New Features
are integral to
5th Generation 
ROVER RACKS


-  All welds are checked before rack is powder coated, for look and strength.

- All racks are made from heat treated & pre-galvanized steel, so it won't bend under stress.  Same weight, stronger steel.

-  Harder, more durable hammered powder coating finish is now standard.

-  All Stainless Steel Hardware Included with every roof rack.

 

Frequently asked Questions
Factory Direct Land Rover Accessories
 

 

Q- What is the height if the racks?
A- The standard and Off-Road Challenge are 17". The Low Profile is 15".  This measurement is to be added to the inside of the gutter above the rear wheel to give you the overall height of your vehicle.
Q- What are the 1 type of flooring?
A-
We have Contractors flooring.  Contractors flooring is additional tube bars in the basket level.
Q- Will Yakama ski, bike, and/or kayak accessories fit?
A-
Yes, as well as other companies that are made to fit 1 inch tubing.
Q- What is the load rating?
A- Although they have not been put through a professional test, it's not what the rack can hold but rather what your gutters can hold.
Q- What is the lead time?
A- Usually runs 2-3 weeks
Q- How many light mounts?
A- Four on the front and one on the rear.
Q- What kind of material are the racks made from?
A- .065 1 inch galvanized steel tubing
Q- How much do the racks weigh?
A-
About 90 pounds.
Q- What accessories are offered?
A- We offer optional flooring, limb riser mounts, high-lift jack mount, axe mount, shovel mount and additional light mounts. 
Q- What is an Off Road Challenge Rack?
A- A Standard Voyager Rack with an added hi-lift jack mount, a light protection bar and 2 limb riser mounts and extra rear antenna/light mount.
Q- Do I need to drill to attach a roof rack?
A- No!  The rack comes in one piece and you set it in your gutters.  Then use the 8 mounting brackets provided to secure the rack to your gutters.  You will need your own 13mm or ½ wrench or socket setup.
Q- Can I customize an order?
A-
Yes, we will customize any order to fit your needs.

 

 

Do you skimp on materials or  quality?  

Absolutely not.  We take Rovers very seriously, and won't sell anything unless we would personally use it.  FACT!!!!!  We have sold hundreds of our racks to VERY satisfied customers.  Become one and find out !!!!  

Where are you located, and where do you off-road ?

Port Charlotte, Florida.  We will, from time to time, travel out of state- but, unfortunately, we don't have too much time to travel to events...

Will we take care of you?

Absolutely.  We will go the extra mile, and have proven do so.